Climax LM5200, Руководство по эксплуатации

Страница: 48 / 102

Page 46 LM5200 Operating Manual
13. Tighten the slide block setscrew against the clamp block until all detectable slack (i.e.,
clearance between chain links) is removed from the chain.
Figure 17. Safety tether chain installation
WARNING
If any slack remains in the chain, the ram could slip, shift, or fall during
machine operation. Even a very short drop may cause the chain shackle
to fail, potentially resulting in death or serious crushing injury.
14. Torque the slide block hex head screw to 150 ft-lb (200 Nm).
Removing the Ram Tether Kit
WARNING
If the ram of the linear mill is oriented vertically, do not remove the ram
tether kit without first supporting the ram with rigging. Attempting to do
so may cause the ram to slip or fall, potentially causing death or serious
crushing injury.
To remove the Ram Tether Kit from the linear mill, complete the following tasks.
1. Do the installation tasks in Section Installing the Ram Tether Kit on page 43 in reverse
order.
2. Install the original clamp block on the linear mill bed.