19
Pendant, CTC-1041RV will not emit any
warning beeps during Reporting.
For learning
Silent Pendant
:
Step 1:
Enter
93
+
#
on the phone set, then
a short beep will be heart via the
phone set.
Step 2:
Press the Pendant Button within 60
sec.
Learning can only be completed
within the signal reception range of
CTC-1041RV.
If no signal is received within 60
sec, CTC-1041RV will emit a long
beep and automatically returns to
Programming mode.
Step 3:
CTC-1041RV will emit 2 beeps to
indicate that Silent Pendant is
learnt-in successfully.
Adding a Pendant for a second
time is prohibited unless it is
removed from the system first.
If
one long beep
is emitted
instead of 2 beeps, it indicates:
The device has already been
learnt-in.
Another device has been learnt-
in before.
Commands 94
Learn-In Device
Up to 7 devices can be learnt into CTC-
1041RV by using Command #94.
The available devices that can be learnt-in
Command #94 are:
PIR Sensor ----- PIR
Smoke Detector ---- SD
Carbon Monoxide ---- CO
Fixed Panic Button ---- PB
Wrist Transmitter ---- WTR
Pendant Transmitter ---- WTR
Water Sensor ---- WS
Fall Sensor ---- FS
Talking Pendant ---- WTRVS
Call Point ---- CP-23
Voice Satellite ---- CTC-808RV
Step 1:
Enter
94
+
#
on the phone set, then
a short beep will be heard via the
phone set.
Step 2:
Press the learn button on the
device within 60 sec.
Learning can only be completed
within the signal reception range of
CTC-1041RV.
If no signal is received within 60
sec, CTC-1041RV will emit a long
beep and automatically returns to
Programming mode.
Step 3:
CTC-1041RV will emit 2 beeps to
indicate the device is learnt-in
successfully.
Adding a Pendant for a second
time is prohibited unless it is
removed from the system first.
If
one long beep
is emitted
instead of 2 beeps, it indicates:
The device has already been
learnt-in.
When an 8
th
device is attempted
to learn-in.
Step 4:
Repeat steps 1-3 until all devices
are learnt-in.
<
<
N
N
O
O
T
T
E
E
>
>
Adding a device for a second time is
prohibited unless it is removed from
the system first.
Command 98
Factory Default Reset
To Reset CTC-1041RV to factory default
settings, enter (
98
) and then (
#
).
After one short beep, continue by entering
(
) and then end with another (
#
), one
beep will be heard for termination.
Once the
Factory Default
Reset
is
executed, all the programmed data is
returned to its default value and all the
devices that have been learnt-in are
removed. You have to do the programming
and learn-in the device one by one again.
Command 99
Exit Programming Mode
Содержание CTC-1041RV
Страница 1: ...c August 12 2013 ...
