Climax CTC-1041RV, Руководство пользователя

Страница: 10 / 37

7
3. System Configuration
3.1. Entering Programming
Mode
Three CTC-1041RV programming modes are
available: Local Programming Mode, Remote
Programming Mode, and via CTC-835
Handheld Programmer (sold separately).
3.1.1. Local Programming Mode
(Optional)
From Idle mode, follow the steps below to
enter Local Programming mode.
Step 1. Plug in the telephone set into
LOCAL PROGRAMMING jack
located on the rear side of CTC-
1041RV.
Step 2. Pick up the handset.
RED LED lights up.
Step 3. Enter default ACCESS CODE, 1111
followed by # .
Step 4. CTC-1041RV will emit 2 short beeps
and the red LED starts to flash,
indicating it is in
Programming Mode.
Step 5. Proceed to program system by
referring to the Commands in section
3.2 Programming Your 1041RV .
<
<
N
N
O
O
T
T
E
E
>
>
Local programming is prohibited when
AC Power fails.
The first digit of Access Code must be
entered within 15 seconds, otherwise
CTC-1041RV will exit automatically.
To exit Programming mode, enter 99
followed by # , or place the handset
on hook, or disconnect the
Programming telephone set.
3.1.2. Remote Programming Mode
To allow Remote Programming, there are two
options for CTC-1041RV to answer the
incoming calls.
(1) Auto Answering by ring count
(2) Dial in twice (Ring Count disable)
The two options are set by Command #41.
Please refer to
Command 41
under section
3.2 Programming your 1041RV .
3.1.2.1. Auto Answering by Ring Count
By using Command 41, you can set the
number of rings for CTC-1041RV to answer
(
20-Rings is set as factory default).
Step 1. Dial CTC-1041RV and wait for CTC-
1041RV to answer.
Step 2. Enter 1111 (default 4-digit Access
Code) followed by # , via the phone set.
Step 3. CTC-1041RV will respond with two
quick beeps to indicate it is ready for
Remote Programming. The RED LED
will flash as a visual indication.
Step 4. You are now in Programming Mode .
Proceed to program by referring to the
Command
in section 3.2
Programming Your 1041RV .
3.1.2.2. Dial in Twice (Ring Count Disable)
If 00 is set in Command 41, it means CTC-
1041RV is disabled to auto answer the
incoming calls by ring count. If Remote
programming is required, you will need to call
CTC-1041RV twice.
Step 1. Dial CTC-1041RV and hang up after
first 2 rings, wait for another 8-20 sec
then call again. CTC-1041RV will
answer the call on the first ring. You
will enter the Remote Programming
Mode after the first ring from the 2
nd
call.
Step 2. Enter 1111 (the default 4-digit Access
Code) followed by # , via the phone set.
Step 3. CTC-1041RV will respond with two
quick beeps to indicate it is ready for
Remote Programming Commands.
The RED LED will flash as a visual
indication.
Step 4. You are now in Programming Mode .
Proceed to program by referring to
the
Command in section 3.2
Programming Your 1041RV .
<
<
N
N
O
O
T
T
E
E
>
>
The first digit of Access Code must be
entered within 15 seconds, otherwise
CTC-1041RV will exit automatically.