1.
With the ignition off, press and HOLD the Valet/Program switch.
2.
Turn on the ignition.
3. Release the Valet/Program switch.
4. Press and release the Valet/Program switch within 5 seconds. The LED status
indicator will flash in groups indicating the last two zones that triggered the
unit for one minute or until the ignition is turned off.
NOTE: The Warning Zone triggers are not stored to memory and will not be reported.
Safety Check
Before vehicle reassembly, the remote system must be checked to ensure safe and trouble-free
operation. The following test procedure must be used to verify proper installation and operation of
the system. The installation must be completed before testing, including connection to the brake
switch and hood switch.
1. Test the BRAKE shutdown circuit: With the vehicle in Park (P), activate the remote engine
starting system. Once the engine is running, press the brake pedal. The engine should shut down
immediately. If the engine continues to run, check the brake circuit connection.
2. Test the HOOD PIN shutdown circuit: With the vehicle in Park (P), open the hood. Activate
the remote engine starting system. The vehicle should not start. If the starter engages, check your
hood pin and connections.
NOTE: If programmed for Diesel Mode, the system will turn on the ignition, but the starter should
not engage with the hood open.
3. Test the NEUTRAL SAFETY shutdown circuit:
IMPORTANT!
Make sure there is adequate clearance to the front and rear of the
vehicle before attempting this test.
42
©
2001
Directed Electronics, Inc.
