H1/1 ORANGE (-) Ground-When-Armed Output
This wire supplies a (-) 500 mA ground as long as the system is armed. This output ceases as soon
as the system is disarmed. The ORANGE wire is pre-wired to control the Directed P/N 8618
starter interrupt relay.
NOTE: If connecting the H1/1 ORANGE wire to control another module, such as a P/N 529T or
P/N 530T window controller, a 1 amp diode (type 1N4004) is required. Insert the diode as shown
in the following diagram:
H1/2 WHITE (+/-) selectable light flash output
As shipped, the H1/2 WHITE wire should be connected to the (+) parking light wire. If the light
flash polarity jumper near the main plug is moved to the opposite position (see the
Programming
Jumper
section of this installation guide), this wire supplies a (-) 200 mA output. This is suitable for
driving (-) light control wires in Toyota, Lexus, BMW, some Mitsubishi, some Mazda, and other
models.
NOTE: For parking light circuits that draw 10 amps or more, the jumper must be switched to a
(-) light flash output. (See the
Programming Jumpers
section of this guide.) P/N 8617 or a standard
automotive SPDT relay must be used on the H1/2 light flash output harness wire.
IMPORTANT!
Never interrupt any wire other than the starter wire.
8
©
2001
Directed Electronics, Inc.
