Feature Menu 3 - Remote Start Features
Feature Descriptions
The features of the system are described below. Features that have additional settings that can be
selected only when programming with the PC interface or Bitwriter are indicated by the following
icon:
Feature Menu 1 - Basic Features
1-1 ACTIVE/PASSIVE ARMING:
When active arming is selected, the system will only arm when
the transmitter is used. When set to passive, the system will arm automatically 30 seconds after the
last door is closed. To alert the consumer of passive arming, the siren will chirp 20 seconds after the
door is closed. This provides the consumer with an audible warning prior to the system actually
arming. At the 30 second mark, the system will arm, but the siren will not chirp.
1-2 CHIRPS ON/OFF:
This feature controls the chirps that confirm the arming and disarming of
the system.
1-3 IGNITION CONTROLLED DOOR LOCKS ON/OFF:
When turned on, the doors
will lock three seconds after the ignition is turned on and unlock when the ignition is
turned off. The TechSoft Programmer or the 998T Bitwriter will display separate steps for ignition
lock and ignition unlock. They can be programmed on or off independently.
1-4 ACTIVE/PASSIVE LOCKING:
If passive arming is selected in Feature 1-1, then the system can
be programmed to either lock the doors when passive arming occurs, or only lock the doors when
Feature Number
One-chirp setting
Two-chirp setting
3-1
Engine checking on
Engine checking OFF
3-2
Engine checking TACH
Engine checking VOLTAGE
3-3
Run time: 12 minutes*
Run time: 24 or 60 minutes*
3-4
Parking lights flashing
Parking lights constant
3-5
Crank time 0.6 seconds
0.8, 1.0, 1.2, 1.6, 1.8, 2.0, 4.0
3-6
Voltage check - high
Voltage check - low
3-7
Auxiliary output - factory disarm
Special accessory
3-8
Status output
Factory re-arm output
3-9
Anti-grind ON
Anti-grind OFF
34
©
2001
Directed Electronics, Inc.
