Clifford Cyber 4, Руководство по установке

Страница: 7 / 24

Wir ing De scrip tion for 2- Pin Con nec tor
Pin Wire Color Con nects to
1 White/Red Starter or Ignition Interrupt
2 White/Red Starter or Ignition Interrupt
Wir ing De scrip tion for 24- Pin Con nec tor
Pin Wire Color Con nects to
1 Violet LED output (+)
2 Green Armed output (-)
3 Blue Sensor input warning zone (-)
4 White Valet Switch input (-)
5 Gray/Blue Auxiliary B output (-)
6 Gray/Violet Auxiliary A output (-)
7 White/Brown Ignition Input
8 Orange Optional Sensor (-)
9 Gray Door trigger input (+) or (-)
10 Gray/Yellow Trunk and hood trigger input (-)
11 Orange Dual-Zone Piezo Sensor input trigger zone (-)
12 Yellow Siren output (-)
13 Black
Battery Negative (ground for the Dual-Zone Piezo Sensor, optional
sensor and LED connectors, Valet Switch)
14 Red Battery positive with 5 Amp fuse
15 Brown/Red Interior light supply
16 Red/White Battery positive with 20 Amp fuse
17 Brown Parking light output (+)
18 Brown Parking light output (+)
19 Gray/Orange Door unlock normally closed
20 Gray/Green Door lock normally closed
21 White/Orange Door unlock comm.
22 Red/Green Door lock normally open
23 Red/Orange Door unlock normally open
24 White/Green Door lock comm.
Pas sen ger Com part ment Con nec tions
Con trol Unit and An tenna
The Cyber 4 con trol unit must be in stalled in side the ve hi cle. Un der no
cir cum stances should the unit be in stalled un der the hood or other simi larly
hos tile en vi ron ment.
1. Select an area behind the dash to mount the control unit using wire ties, but do not
permanently affix it until all wiring and testing is complete.
2. Run the antenna either up the window pillar or under the dash, away from metal. Do not
fold the excess cable or antenna wire. Do not make hard, sharp bends.
Door Trig ger/In te rior Light Sup ply
The Cyber 4 has self-programming door trigger polarity. Door triggers on most autos are
negative (except most Rolls-Royce and Ford autos). To determine door trigger polarity, use
the following procedure:
1. Find the wire coming off the rear of the vehicle door switch.
2. Connect the negative voltmeter lead to ground.
3. Find the one wire that shows +12 volts when the switch is pressed in and 0 volts when
released. This is a negative trigger door wire.
4. If you don’t get the indications noted in step 3, find the one wire that shows 0 volts when
the switch is pressed in and +12 volts when released. This is a positive trigger door wire.
5