© 2004 directed electronics, inc.
21
sensor harness, 4-pin connector
red and black wires
These wires supply constant 12 volts and ground to the sensor.
blue and orange wires, zone 3 zone 8
These wires are multiplex inputs. If a (-) input of less than 0.8 seconds is supplied to
either wire, the Warn Away
®
response will occur. A (-) input of longer than 0.8 sec-
onds to either wire will initiate the triggered sequence and report Zone 3 or Zone 8.
mounting the receiver/antenna
N
NO
OTTEE:: Be sure not to bundle excess cable as this will reduce the range.
The receiver/antenna position should be discussed with the vehicle owner prior to
installation since the antenna may be visible to the vehicle’s operator.
The best position to locate the receiver/antenna is centered high on either the front or
rear windshield. For optimal range, the antenna should be mounted vertically. It can
be mounted horizontally in relation to the windshield or under the dashboard away
from metal, but range will be reduced. Metallic window tint can also affect range, so
this should be a consideration when determining the mounting location.
After determining the best mounting location, follow these steps:
1.
Clean the mounting area with a quality glass cleaner or alcohol to remove any
dirt or residue.
2.
Plug the receiver/antenna cable into the receiver/antenna.
3.
Mount the receiver/antenna with double-sided tape.
4.
Route the receiver/antenna cable down the window pillar to the control module
and plug the cable into the control module.
BLUE WIRE
ZONE 3
ORANGE WIRE
ZONE 8
BLUE WIRE FROM PLUG-IN
SHOCK SENSOR
BLUE AND GREEN WIRES
FROM DUAL STAGE SENSOR
ORANGE WIRE FROM
PLUG-IN SHOCK SENSOR
X
X
CUT
