www.directed.com
8
h1/9 green (-) door trigger input - zone 4
Most vehicles use negative door trigger circuits. Connect the GREEN wire to a wire
showing ground when any door is opened. When connecting to newer model vehicles
there is generally a need to use individual door triggers. This wire will report Zone 4.
N
NO
OTTEE:: If using a door trigger wire that has a delay, the installer-selectable program-
ming grid or the Cliffnet Wizard can be used to turn the door ajar warning off.
h1/10 red (+) 12v constant
Before connecting the RED wire, remove the supplied fuse. Connect to the battery pos-
itive terminal (be sure to use the supplied fuse holder and a 5 amp fuse) or the con-
stant (+) 12V supply to the vehicle fusebox.
h1/11 brown (+) siren output
Connect the BROWN (+) siren output wire to the RED wire of the 514C. Connect the
BLACK wire of the siren to (-) chassis ground at the same point you connect the control
module’s BLACK ground wire.
h1/12 white/red light flash input
This wire is the input for the on-board dual light flash relay. If the vehicle has positive
parking light activation wires, connect this wire to a constant (+) 12V source that is
fused at 15A or higher (be sure to use the supplied fuse holder and a 15 amp fuse).
If the vehicle parking light activation wire is negative, connect this wire to a chassis
ground location.
