www.directed.com
34
Note #4: RPM programming
z
Drive the vehicle to an open area and allow the engine to warm up until the
engine RPM drops to normal idle speed.
z
Place the engine in park or neutral and set the parking brake.
z
Enter the feature and press the arm/disarm button.
z
The lights will flash twice to confirm the engine RPM has been learned.
N
NO
OTTEE:: If only one flash is seen, the engine RPM was not successfully learned. Test the
tach wire connection and retry.
z
Turn the ignition off and activate remote start to test.
Note #5: PIN Programming
A PIN code can have one to four digits; each digit can be from 0-9.
N
NO
OTTEE:: A PIN code cannot begin with a zero.
z
Programming Procedure
1.
Enter the feature location in the user-selectable programming grid.
2.
Immediately press and release
of the PlainView 2 Valet switch.
3.
Select each digit by pressing
1-9 times, and then press
to enter
the number into the system. To enter a zero, press
only.
z
To program a PIN code of 1032:
1.
Press and release
once and
once. You will hear one chirp.
3.
Press and release
once. You will not hear a chirp after programming
a zero.
5.
Press and release
three times, and then press
once. You will hear
three chirps.
6.
Press and release
two times, and then press
once. You will hear
two chirps.
4.
Wait for two siren chirps after a five second pause or five seconds after the
last digit has been entered if using less than four digit code number.
5.
Turn off the ignition; the siren will chirp three times.
6.
The programming mode is now exited.
z
PIN Code Confirmation Procedure
Begin this procedure within 15 seconds of finishing the programming sequence
or the new code will not be set.
