Multiple- event To tal Re call™
Your Concept 600 system’s memory records the identity of the last eight activated or
malfunctioning triggers and sensors, which allows your installer to instantly track down
malfunctions. To identify the triggers and sensors held in the system’s memory, use the
following procedure:
1. Remotely arm and disarm while pressing and holding the unmarked button on the
PlainView 2 switch.
2. The LED will flash 1-10 times to indicate the most recently activated point, pause,
flash 1-10 times to indicate the second most recently activated point, and so on.
3. Write down the number of flashes between pauses and refer to the chart on the
previous page.
AutoLock and Aut oUn Lock
Please note: The AutoLock and AutoUnLock features are not available on
some vehicles, such as Volkswagen and Audi.
For your safety and that of your passengers, the doors automatically lock after you begin
driving (when the engine reaches a predetermined RPM). If you prefer, you may set
AutoLock to lock the doors the instant you turn on the ignition (see
User-selectable
features
on pages 21-22). When you turn the ignition off, AutoUnLock automatically
unlocks the doors.
To suit your preferences, you may turn on or off
either or both
the AutoLock and/or
AutoUnLock features. If you have the optional DataPort connector and CliffNet Wizard
software you can even adjust whether the doors lock at a higher or lower engine speed
(see Optional CliffNet Wizard on page 19).
Smart boot re lease op tion
If the optional remote boot release feature was installed, you may use button 2 (master
remote control) or button
(companion remote control) to remotely release the boot
latch.
Your system has a built-in electronic interlock to prevent unintentional activation of the
remote boot release when you drive, or when the system is armed. This interlock requires
installer programming, so if you have the remote boot release option, you may want to
verify that it will
not
activate when the system is armed.
Smart Powe rUp™ 2
If power to the system is ever removed, SmartPowerUp 2 ensures that your Concept 600
system automatically restores itself to its previous state when power is restored. So if a
thief disconnects the power and then restores it in an attempt to start the car, the system
will re-arm and instantly sound the siren whilst immobilising the vehicle. If your vehicle
is to be serviced, just put it in valet mode. If your mechanic must interrupt power, the
system will automatically return to its valet mode state when power is restored; there will
be no alarm activation.
18
