Auto mat ic re mote con trol low- battery warn ing
If your remote control battery is very low, you will hear a low-pitched chirp whenever
you disarm rather than the high-pitched chirp that you normally hear. The system will
continue to sound this low-pitched chirp every time you disarm until you replace the
battery. Since this is a warning indication, you will hear this low-pitched chirp regardless
of whether you have the system set to QuietChirps, LoudChirps or no chirps and even if
you use the silent disarming feature (see page 8).
Re mote con trol bat tery re place ment
Replacement of a remote control battery is simple, but any Authorised Clifford Dealer will
be happy to do it for you without cost provided you buy the replacement battery at their
shop (it’s also a good idea to keep a spare of each battery type in your glove box just in case).
Mas ter re mote:
1. Unscrew the retaining screw on the back of the remote control.
2. Carefully pry apart the remote control case with your fingernails or a small, thin
screwdriver blade near the keyring opening (you may leave the keyring in place).
3. Remove the old battery noting the + and – indications and replace it with the new one.
4. Put the enclosure back together by first aligning the LevelShift button side, then the
top of the remote, then snap the case back together at the bottom.
5. Reinsert the retaining screw but
DO NOT OVERTIGHTEN.
Com pan ion re mote:
1. Insert a small, thin screwdriver blade in the slot near the keyring opening (you may
leave the keyring in place) and turn it to separate the two halves.
2. Remove the old battery noting the + and – indications and replace it with the new one.
3. Put the enclosure back together by first aligning the top of the remote, then snapping
the case back together at the bottom.
Add ing new re mote con trols
For other drivers of the vehicle in your family, you can purchase additional remote controls
from any Clifford Dealer (or ring our UK Customer Service Department on 0800 929949
or 0181 646 8440). Concept 600 responds to as many as four remote controls.
NOTE: Your Concept 600 will re spond only to Concept 100, 300, 400 and 600
type ACG 2 re mote con trols. Older Clif ford ACG and non- ACG re mote
con trols are not com pati ble with the Concept 600.
To add a new remote, use the
Add new remote
feature (column 1, row 1) of the
User-selectable
features
on pages 21-22. You may also assign unused buttons and/or button combinations
from the remote controls of other Concept 100, 300, 400 and 600 systems to your
Concept 600 as noted in column 4 of the
User-selectable features
on pages 21-22.
How to erase the codes of lost or sto len re mote con trols
If one of your Concept 600 remote controls is ever lost or stolen, you can erase it from
the system memory to ensure that the missing remote can never again be used to disarm
your system. To do so, use the
Clear All Remotes
feature noted in the
Table of
User-Selectable Feature
s (feature column 2, row 6) on page 22. This
Clear All Remotes
feature will erase all remote from the system memory. Then reprogram each remaining
and/or replacement remote control as noted in the
Adding new remote controls
section above.
11
