28
P2291BA | 2020-05
Apex Tool Group
9
EN
Additional messages from »PLUS«
Depending on the software used, different messages relat-
ing to the process with the PLUS system can be pro-
grammed to appear on the display in addition to the
standard tool displays.
Tool memory could not be read.
Return tool to
Sales & Service Cen-
ters
for repair.
Two-stage start button defective.
Return tool to
Sales & Service Cen-
ters
for repair.
Transducer reference voltage error
Return tool to
Sales & Service Cen-
ters
for repair.
Transducer calibration voltage error
Tool was not discharged at time of cali-
bration.
1. Allow tool to discharge and try
again. If this does not help:
2. Return tool to
Sales & Service Cen-
ters
for repair.
Transducer offset voltage error
Tool was not discharged at time of cali-
bration.
1. Allow tool to discharge and try
again. If this does not help:
2. Return tool to
Sales & Service Cen-
ters
for repair.
General collective error
Return tool to
Sales & Service Centers
for repair.
The battery is empty.
Replace the battery.
The min. torque for evaluation was not
reached.
Repeat the current rundown.
The service counter has reached the
warning threshold for the service inter-
val.
Acknowledge message once.
The message only appears again
once the system is switched back
on.
Tool
Error
Ident
Tool
Error
Start
Transd
Ref.V.
Error
Trans
CAL
Error
Trans
Off
Error
Unknow
Error
Batter
empty
-> off
No
result
Servic
interv
warnng
The service counter has reached the
maximum number of rundowns. Tool
has locked.
Return tool to manufacturer for
repair.
Initialization error
LiveWire Memory
Chip
.
1. Switch the tool on and off again.
2. Check the parameters in the soft-
ware controller.
3. Insert the WLAN chip again.
Replace if necessary.
4. Return tool to manufacturer for
repair.
WLAN module programming initializa-
tion fault.
1. Switch the tool on and off again.
2. Check the parameters in the soft-
ware controller.
3. Return tool to manufacturer for
repair.
The authorized WLAN offline time for
the connection was exceeded. Tool is
locked until the connection is restored or
the tool moves within the wireless trans-
mission range.
Move the tool within range of the
WLAN access point.
1st
line
Text/
Color
2nd
line
Text/
Color
3rd
line
Text/
Color
Description
NEW
PARA
METE
RS
New parameters have
just been adopted.
This does not mean that
these parameters will
have an immediate
effect on the nutrunner/
fastening process.
The message is deleted
when a new job is initi-
ated.
PLUS
None
TMU
Could not determine
TMU.
The message is deleted
when a new job is initi-
ated
Servic
Interv
LMC
Error
WLAN
error
Tool
Locked
Offline
