
Visit
www.ClearSpan.com
for additional products and customer assistance.
CLEARSPAN
™
SUNBURST POLY BUILDINGS
1
SIDE STRUT INSTALLATION
There are four (4) side struts for the shelter. These struts
are positioned between the end rafters and the first interior
rafter on each side of the shelter.
Complete these steps to install the four (4) side struts:
Gather the parts:
Struts
QH1400 and QH1402 band clamps (previously
installed)
Locate one strut and position it between one end rafter
leg and the leg of the first interior rafter as shown
below.
•
•
1.
Attach one end of the strut to the band clamp as shown
in the diagram below.
2.
Strut
End Rafter
Band Clamp
Attach the remaining end of the strut to the bottom
purlin using a nut and bolt. See the diagram below
3.
Repeat the above steps to attach the remaining side
struts to the shelter.
After securing the struts, verify that all clamps are
secured with a Tek screw to the rafters.
Verify that each pipe splice (purlin and rafter) is
secured with a Tek screw.
Complete the next procedure to anchor the assembled
frame.
4.
5.
6.
7.
ANCHOR THE ASSEMBLED FRAME
At this point, anchor the shelter frame. Consult the
MUST READ document for anchoring information and
suggestions. Please call customer service at 1-800-245-
9881 for additional anchoring information.
CAUTION
: The anchor assembly is an integral part of
the shelter construction. Improper anchoring may
cause instability and failure of the structure to perform
as designed. Failing to anchor the shelter properly
will void the manufacturer’s warranty and may cause
serious injury and damage.
NOTE:
Head of bolt on the band clamp must face the
toward the outside of the shelter.
Strut
End Rafter
Interior
Rafter
Customer supplied
baseboard.
Ground
Level
Purlin
FINISH ROUGH EDGES
Gather the parts:
Duct tape (supplied by customer)
Metal file
Check for any sharp edges on the frame and file them
smooth so they will not cut the cover.
Apply two layers of heavy duct tape on all pipe
connections and clamps that may contact the cover.
Continue with the end frame installation.
•
•
1.
2.
3.