ClearOne V-There 2000, Руководство по установке и эксплуатации

Страница: 66 / 80

ClearOne Communications ~ www.clearone.com
60
Appendix D ~ Compliance Statements and Warranty
The following steps need to be performed.
1. Consult the Technical Support section at www.clearone.com for the location of
latest release. Download the required file—this contains a single file called
nk.bin. Unzip the file to get the nk.bin file.
2. Connect a serial cable to port A (upper connector) of V-There and a PC running
HyperTerminal. Set the communications settings on the PC to 57600 baud, 8
data bits, 1 stop bit, no parity, no flow control. Switch on V-There and
simultaneously hit any button on HyperTerminal to bring up the V-There loader
menu. If the text does not stop at the loader, switch off V-There and try again.
3. Press the 4 button (Download over Serial, copy to Flash and Run). On
HyperTerminal, start the Transfer/Send File dialog. Select NK.bin as the file
and 1K Xmodem as the protocol. When finished, V-There will be running the
new version.
North American users
1LXUSA-32757-XD-N
The Federal Communications Commission warns the users that changes or
modifications to the unit not expressly approved by the party responsible for
compliance could void the users authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Re-orient or re-locate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that where the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Appendix D: Compliance Statements and Warranty