ClearOne V-There 2000, Руководство по установке и эксплуатации

Страница: 13 / 80

7
Getting Started ~ Hardware Setup
All connections are made at the back of the V-There. The diagram above shows the
rear panel connections for the V-There 2200 model. For the 2100 model, the only
difference is that there is only one ISDN connector. The 2000 model has no ISDN
connector.
Before you begin to connect your V-There, ensure that the on/off switch is in
the Off state (down) and that the power supply has been connected to V-There.
The table below describes the purpose of each of the connectors on the rear
panel.
ClearOne Communications ~ www.clearone.com
You can also connect other devices to the V-There. For more information, see the
connection information on the following pages.
Connector Description
Ethernet
This connector provides video input from the V-There camera.
This connector provides power and PTZ capabilities for the main
camera and connection to the IR receiver.
If you want to use your V-There to make or receive calls over
your local area network (LAN), connect the gray Ethernet cable
to this connector.
Hardware Setup
Figure 2.2 Rear panel (2200 model shown)
Camera Control IR
Camera Video
The cable connectors are
color-coded to facilitate
straightforward
connection.
✍