User Guide
|
Eclipse HX-PiCo
Page 54
Note:
If a DHCP server cannot be located on power up, then the Eclipse HX-PiCo uses the
link local (system default) IP address (
169.254.0.100
). If the PC running the EHX
software is also DHCP enabled, and is also unable to locate a DHCP server, then the
matrix and the PC can communicate on the link local network address.
Before setting the IP address for the Eclipse HX-PiCo, you must first disable DHCP.
Clear-Com recommends using the EHX configuration software to first disable
DHCP and set the IP address.
Note:
For more information about EHX, including setting IP addresses, see your EHX
documentation (including EHX Help).
However, you can also use the menu system on the Eclipse HX-PiCo to change the
IP address: To set the IP address for the Eclipse HX-PiCo:
1)
From the Main menu, select System.
The System menu is displayed.
2)
From the System menu, select IP address.
The IP Address screen is displayed.
Note:
If the matrix software has been reloaded or reset, or a DHCP server
was not found, the local link (default) IP address of
169.254.0.100
is displayed.
3)
In the IP Address screen, select DHCP. If DHCP is enabled, the following is
displayed:
DHCP Enable [ X ]
Disable DHCP by deselecting DHCP Enable.
4)
Return to the IP Address screen. To begin changing the IP address, scroll to
the first digit of the IP Address. Press the setup/enter rotary control.
5)
Rotate the setup/enter rotary control clockwise or counter clockwise to
scroll through the available digits. When the desired digit appears in the
display, press the setup/enter rotary control to select and save it.
6)
Rotate the setup/enter rotary control clockwise or counter clockwise to
scroll to the next digit and repeat steps 3 and 4. Continue to go from digit
to digit, until the entire IP address has been entered.
7)
Repeat the same procedure for the Subnet Mask field. Scroll to and select
Save.
