User Guide
|
Eclipse HX-PiCo
Page 22
5
Installing the Eclipse HX-PiCo
This chapter describes how to install the Eclipse HX-PiCo matrix frame to a standard
19” (48.26 cm) rack.
It also shows you how to connect the matrix to the mains power supply and
external devices, including other matrix frames (matrices) and user panels.
Note:
For an overview of the Eclipse HX-PiCo, see 3. Overview.
5.1
Preparing to install the Eclipse HX-PiCo
Checking the shipment
When the Eclipse HX-PiCo is received inspect the boxes for shipping damage.
Note:
The Eclipse HX-PiCo distributor is not responsible for shipping damage. If there is
damage to the shipment, report the damage to the carrier.
Check the packing list and verify that every item on the list has been received.
Save all packing materials in the event any items need to be returned.
16)
Unpacking the System
The system comprises the Eclipse HX-PiCo matrix hardware, and the software for
operating the matrix frame.
The customer must supply:
A standard 19 inch wide (48.26 cm) Electronics Industry Association rack in
which to install the matrix.
A personal computer to run the EHX configuration software (see 4.2 EHX
configuration software).
Shielded CAT-5 cables to connect the matrix to user panels, interface
modules, interface frames and other intercom devices.
To install an Eclipse HX-PiCo:
17)
Remove the Eclipse HX-PiCo from its shipping carton.
18)
Place the matrix frame (matrix) in a standard Electronic Industry
Association equipment 19” (48.26 cm) rack.
Environmental information:
Leave clearance on all sides of the matrix to
ensure proper airflow. Do not block ventilation vents.
