CleanSpace CS302, Инструкция пользователя

Страница: 36 / 90

36
WARNING
NEVER DRY THE MASK OR EXHALATION VALVE WITH A CLOTH THAT MAY LEAVE BEHIND LINT.
Lint contamination of the exhalation valve may cause it to leak, resulting in overexposure to
contaminants and lead to sickness.
Reassembling the Mask
Refit the inner mask
The frame of the inner mask has two ribs on the bottom. Fit these into the
slots in the bottom of the main valve block
Push the top of the inner mask firmly forwards until both snaps engage,
holding it in place against the main valve block
Lower the rain cover
WARNING
Using a full face mask with the rain cover raised can cause the exhalation valve to vibrate, which
you may notice as a buzzing noise. Lower the rain cover for correct operation.
CLEANING THE BLOWER
WARNING
The blower contains a battery, sensitive electronics and a motor. NEVER immerse it in water or use
anything wetter than a damp cloth to clean it.

After removing the mask, remove the neck support. Leave the filter in place to prevent any dust or liquids
from getting into the blower.

 Using CleanSpace Cleaning Wipes, wipe down the outside of the blower. The blower can also be cleaned
with a damp cloth.


Allow the blower to air dry in a clean environment. The blower can also be hand-dried with a clean lint-
free cloth. Note: Do not dry the blower by exposing to heat (i.e. hair dryers or heaters) or
compressed air .

CLEANING THE HARNESS AND NECK SUPPORT
The harness and neck pads can be washed in warm soapy water or machine washed. After cleaning, allow the
harness and neck pads to air dry in a clean environment.
Note: Do not dry the harness or neck support by exposing directly to heat i.e. hair dryers or heaters.
WARNING
DO NOT USE COMPRESSED AIR OR A BRUSH TO CLEAN THE FILTER!
HEPA FILTERS ARE VERY EASILY DAMAGED BY THE USE OF COMPRESSED AIR OR BY
BRUSHING.
Misuse of CleanSpace HALO by cleaning the filter may result in overexposure to contaminants and
lead to sickness.