CleanSpace CS302, Инструкция пользователя

Страница: 31 / 90

31
pin on the right of the blower. Swing the filter shut into closed position and hold it firmly against the body of the
respirator with one hand. Press the pin down until back in place.
NOTE: Inlet Tube (Blue cover) on the filter cover of CS3025 is not removable from the filter. Remove the
HALO BIO filter in its entirety and replace with a new one.
IS PUT BACK INTO SERVICE. SEE “TESTING THE BLOCKED FILTER ALARM” AT THE END OF THIS SECTION
TESTING THE BLOCKED FILTER ALARM
After changing the filter, check that the Blocked Filter Alarm is audible and the Filter LED is working.
1.
Remove the mask from the respirator. Using your hand, completely cover the air outlet (see Figure 28).
2.
With the respirator in Standby mode (one or more green LEDs lit), press and release the Power button. The
blue LED will light and the respirator starts blowing.
If no LEDs are lit, press the Power button once to enter Standby mode.
3.
After 5 - 10 seconds, the red Filter LED will light and the blocked filter alarm will sound (2 beeps, repeated
every second).
4.
Reset the machine by pressing the Power button.
If the red Filter LED does not light or the alarm does not sound, check that the outlet is completely blocked.
The outlet is on the left side as you wear the device (see illustration below). If the Filter LED and/or audible
alarm are still not working, do not enter the contaminated zone . Contact CleanSpace for assistance.
Figure 28 – Blocking the air outlet for a blocked filter alarm test
WARNING
WHEN FITTING A NEW FILTER, THE BLOCKED FILTER ALARM SHALL BE TESTED BEFORE
THE RESPIRATOR IS PUT BACK INTO SERVICE. SEE THE HEADING “TESTING THE BLOCKED
FILTER ALARM” BELOW.