CleanSpace CS302, Инструкция пользователя

Страница: 19 / 90

19
 Check the Harness
The Harness should take a little of the weight of the mask and support the blower so that the respirator system sits
level on your head. If necessary adjust the harness. This is done by shortening or lengthening the front straps of the
harness, by sliding the cleats up or down the straps. Remember to shorten or lengthen each side by the same
amount. If necessary the rear strap can also be adjusted – see above.
Figure 20 – Correct CleanSpace HALO Position
 Tighten the mask on your face
Tighten the mask until you do not feel any leaks between the mask cushion and your face.
To tighten the mask, place one hand against the back of the blower and the other over the front of the mask. Push
the blower forwards and the mask back, tightening the fit. You will hear a series of clicks as the mask is tightened.
Be careful to tighten each side by the same amount.
Figure 21 – Tightening Mask
STEP 5 – CHECK MASK SEAL
(STANDARD MASK)
If using the HALO BIO system CS3024 Head Cover, skip to Section 14.
It is essential to do a seal check every time you wear a CleanSpace HALO.
Locate PAF-1009, the red Seal Check Cap. Fit Seal Check Cap over the exhalation valve in the mask. The Cap
should snap into place. See Figure 22
.
PUSH
PUSH