CleanSpace CS302, Инструкция пользователя

Страница: 24 / 90

24
ALL LEDs
FLASH FAIL (Flow <120 l/min)
Do not use the respirator until a new filter has been fitted and / or battery charged
and the test has been repeated with a PASS result.
Reset the respirator by pressing the Power button. Fully charge the battery and / or
replace the filter. Repeat the flow test. If filter is new and battery fully charged but the
respirator fails the test, contact CleanSpace Technology and do not use until it has been
evaluated
** This test is not a battery charge test. Three LEDs means that, as of the moment it is tested, the unit can
deliver high flow. It does not mean the battery is full. You must check the battery condition separately. See
Section 19.
STEP 4 - DON THE MASK
If you have long hair, it is recommended you tie the hair back so that it does not interfere with the seal
between the mask and your face. When you are fitting the mask, check that the seal does not cross your
hairline.
WARNING
DO NOT USE COMPRESSED AIR OR A BRUSH TO CLEAN THE FILTER!
HEPA FILTERS ARE VERY EASILY DAMAGED BY THE USE OF COMPRESSED AIR OR BY
BRUSHING.
Misuse of CleanSpace HALO by cleaning the filter may result in overexposure to contaminants
and lead to sickness.
Loosen all five straps on the
mask harness to their fullest
extent Hold the mask in one
hand while you use the other
hand to pull the harness back
and away from the mask.
Place your chin in the cup of
the mask face seal. Then, pull
the harness over your head.
Donning is best done with a buddy to help you check adjustments and fit!