Clavister Eagle E7, Быстрый старт, Страница: 59 / 76

3.5. Installing a License
Without a valid license installed, cOS Core will run in demonstration mode which means that it
will cease to function after two hours of operation (rebooting the system will re-enable cOS Core
for another two hours). To remove this restriction, a valid license must be installed.
As described in Section 3.2, “Web Interface and Wizard Setup” , when the wizard is used for
initialling configuring Clavister hardware, the administrator can choose to install a license as one
of the wizard steps. Alternatively, a license can be installed separately later and this section
describes the various ways of doing that.
There are three methods for installing a license:
1. Manually through the Web Interface or SCP
This consists of the following steps:
i. In a web browser, go to the Clavister website https://www.clavister.com , select My
Clavister, log in and go to Licenses > Register License.
ii. Select the option Register by Service Tag and Hardware Serial Number.
iii. Enter the Serial Number and Service Tag codes then download a license to the
computer's local disk. For Clavister hardware products, these codes are found on a label
on the unit. The label also has a QR code containing the website and codes which can
be read by a mobile device.
iv. The license file is uploaded to the security gateway through the cOS Core Web
Interface by going to Status > Maintenance > License and pressing the Upload
button to select the license file. Following upload, cOS Core will install the file.
Alternatively, the license file can be uploaded using SCP. cOS Core automatically
recognizes an uploaded license file but it is then necessary to manually to perform a
reconfigure or reboot operation to complete installation.
License installation must be done manually if the cOS Core installation has already had a
license installed before.
2. Automatically through the Web Interface
Go to Status > Maintenance > License and enter the customer username and password,
then press Activate. The license is fetched automatically across the public Internet and
installed.
This option is also only available once and that is when installing a license in a Clavister
hardware product for the first time.
3. Automatically through the CLI
In the CLI, enter the command:
Device:/> license -activate -request -username=myname -password=mypass
The customer username and password is included in the command with the license fetched
automatically across the public Internet. It is then necessary to manually enter the
reconf or
shutdown command to complete installation.
This option is also only available once and that is when installing a license in a Clavister
hardware product for the first time.
Chapter 3: cOS Core Configuration
59