T H E C O N T I N U O U S P O W E R C O M P A N Y
Page 43
Front Panel Fuse(F1) keeps going bad:
•
Possible bad inverter.
On turn on, Unit goes through startup sequence then goes into alarm and inverter does not
turn on:
•
Possible bad inverter.
•
Load on unit may be over Max. rating.
Unit in Alarm, but is still operating OK:
•
Possible over temp.
•
Check fans in the unit to make sure they are running.
In On-line operation, intersection goes into flash when utility power is loss:
•
Check PIM for proper installation and wiring.
•
Options in the program may not be set properly.
5.4 SERVICE
AND
REPAIR
Your
SP Series
UPS is backed by one of the finest customer service teams available. Write
or call them at any time to obtain more information about your unit.
Clary Corporation
1960 S. Walker Avenue
Monrovia, CA 91016
1-800-551-6111
If a problem should occur, it is important that you obtain a Return Material Authorization
(RMA) number from the Service Department to process any unit returned to the factory. In
consulting the factory, always have the unit model number and serial number at hand. This
information is located on the identification label and is essential in retrieving your unit’s
performance and history record.
The RMA number issued to you should appear on the outside of the carton, if the unit is
returned, or on any correspondence regarding your unit. When shipping a unit back to the
factory, try to use the original packing container and shipping materials. The Service
Department cannot take responsibility for any unit damaged in return shipment. All units
must be returned prepaid to:
Clary Corporation
SP Service Center
1960 S. Walker Avenue
Monrovia, CA 91016
