Nitrogen and pure air generator
NitroAir
13
5.
Disassembly and transport
5.1.
Uninstall
• Arrest the generator (see par. 6.5.)
• Wait for depressurizzation
• Switch the generator off(see par. 6.6.).
• Disconnect power supply cable.
• Close all the valves on the air pipeline and disconnect the pneumatic connection.
5.2.
Transport
e
Please remember that during trasport the generator must always stand in verti-
cal position.
Mount the right angled profile in the correct way so that the compressor is bloc-
ked.
1.
Unfasten the rear panel.
2.
Disconnect the fan cable and the ground cable.
3.
See the right angled profile (in red).
4.
Unfasten the screws (1) of the compressor.
5.
Unfasten the screws (2) that block the right angled profile on the base of the
compressor.
6.
Position the right angled profile so that the screws (1) are lodged in the holes.
7.
Position the screws (2) .
8.
Fasten the screws(1).
9.
Fasten the screws(2).
10.
Verify that the compresor is blocked in the correct way, shaking it gently. If the
right angled profile is correctly blocked, the compressor doesn’t move (see fig.
par 4.2.3)
11.
Connect again the fan cable and the ground cable.
12.
Fasten again the rear lower panel.
13.
Position a sheet on the generator indicating that the blocks of the compressor is
mounted.
Reuse, if you have kept it, the original packing; if you haven’t, please realize a
new packing using a pallet of adequate dimensions, and applying very clear and
visible indications such as: KEEP IN VERTICAL POSITION, UP
All manuals and user guides at all-guides.com
