Claas LEXION 7000, Информация и базовые настройки поля

Страница: 30 / 62

The cutterbar is one of the most important parts of the
combine harvester. It is designed to cut and gather the
crop from the field.
The first part of the cutterbar to make contact with the crop
are the dividers. There are two types, a standard and a
long divider.
It is recommended that lifters should be fitted to CLAAS
cutterbars. The lifters should be fitted by placing the first
one on the fifth finger from the RHS of the cutterbar and
then on every fourth one thereafter.
Dividers:
Lifters:
To make the crop lie down before the
auger to aid the feed into the centre of the
cutterbar, move the table in or out.
Make sure that the height of the divider is
set so it does not run on the ground. Set
the height the same as the stubble.
Check the lifters everyday, if they are loose
or bent remove and replace them.
Tips:
Settings: VARIO Cutterbar
29