Cissell FINTUNMAN67, Руководство пользователя

Страница: 8 / 41

Page 8
ADJUSTING DROP-OFF
IMPORTANT!
1. Warning! When placing hanger on conveyor, open end of hanger must point toward cabinet.
A hanger placed on the conveyor backwards may result in a damaged garment.
2. Any make of wire hanger with sufficient clearance may be used on the automatic tunnel
conveyor, but all hangers should be the same to insure proper drop-off.
3. Adjust drop-off so that it barely misses the conveyor links by adjusting nuts on the bracket
inside of tunnel as illustrated above in A of Figure 1.
4. Using the selected hanger, then adjust the height of the drop-off as illustrated above in B of
Figure 1.
5. Adjust lower end of drop-off to desired height for proper sliding of garment and for proper
feed to screw conveyor if used (C of Figure 1).
6. Run a few garments through the tunnel and check to be sure that there is clearance at the
top of hanger, and that drop-off operation is smooth. If hanger does not have enough
clearance perhaps a change in hanger is needed. If the drop-off is not smooth, repeat steps
3 through 5 above.