Cisco Sx350, Руководство CLI

Страница: 865 / 1323

Network Management Protocol (SNMP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 864
43
43.7 snmp-server group
To configure an SNMP group, use the snmp-server group Global Configuration
mode command. Groups are used to map SNMP users to SNMP views. To remove
an SNMP group, use the no form of this command.
Syntax
snmp-server group
groupname
{
v1 | v2 | v3 {noauth | auth | priv} [notify notifyview]}
[read readview] [write writeview]
no snmp-server group groupname {v1 | v2 | v3 [noauth | auth | priv]}
Parameters
•
group groupname —Specifies the group name. (Length: 1–30 characters)
•
v1—Specifies the SNMP Version 1 security model.
•
v2—Specifies the SNMP Version 2 security model.
•
v3—Specifies the SNMP Version 3 security model.
•
noauth—Specifies that no packet authentication will be performed.
Applicable only to the SNMP version 3 security model.
•
auth—Specifies that packet authentication without encryption will be
performed. Applicable only to the SNMP version 3 security model.
•
priv—Specifies that packet authentication with encryption will be
performed. Applicable only to the SNMP version 3 security model. Note that
creation of SNMPv3 users with both authentication and privacy must be
done in the GUI. All other users may be created in the CLI.
•
notify
notifyview
—(Optional) Specifies the view name that enables
generating informs or a traps. An inform is a trap that requires
acknowledgement. Applicable only to the SNMP version 3 security model.
(Length: 1–30 characters)
•
read readview —(Optional) Specifies the view name that enables viewing
only. (Length: 1–30 characters)
•
write
writeview
—(Optional) Specifies the view name that enables
configuring the agent. (Length: 1–30 characters)
Default Configuration
No group entry exists.