Cisco Sx350, Руководство CLI

Страница: 107 / 1323

802.1X Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 106
3
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The silence time is the number of seconds that if an authorized client does not
send traffic during this period, the client is changed to unauthorized.
If an authorized client does not send traffic during the silence period specified by
the command, the state of the client is changed to unauthorized.
The command is only applied to WEB-based authentication.
Example
The following example sets the authentication silence time to 100 seconds:
switchxxxxxx(config)#
interface gi11
switchxxxxxx(config-if)# dot1x timeout silence-period 100
3.24 dot1x timeout supp-timeout
To set the time interval during which the device waits for a response to an
Extensible Authentication Protocol (EAP) request frame from the client before
resending the request, use the dot1x timeout supp-timeout command in Interface
Configuration mode. To restore the default configuration, use the no form of this
command.
Syntax
dot1x timeout supp-timeout
seconds
no dot1x timeout supp-timeout
Parameters
•
supp-timeout seconds —Specifies the time interval in seconds during
which the device waits for a response to an EAP request frame from the
client before resending the request. (Range: 1–65535 seconds).
Default Configuration
The default timeout period is 30 seconds.