Cisco Sx350, Руководство CLI

Страница: 1006 / 1323

Rate Limit and Storm Control Commands
1005 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
50
50.4 storm-control
To enable broadcast, multicast, or unicast storm control on a port, use the
storm-control command in Interface (Ethernet) Configuration mode. To return to
default, use the no form of this command.
Syntax
storm-control broadcast {level
level
| kbps
kbps
} [trap] [shutdown]
no storm-control broadcast
storm-control multicast [registered | unregistered] {level
level
| kbps
kbps
} [trap]
[shutdown]
no storm-control multicast
storm-control unicast {level level | kbps kbps } [trap] [shutdown]
no storm-control unicast
no storm-control
Parameters
•
broadcast—Enables broadcast storm control on the port.
•
multicast [registered | unregistered]—Enables ether all multicast, only
registered multicast, or only unregistered multicast storm control on the
port.
•
unicast—Enables unicast unknown storm control on the port.
•
level level —Suppression level in percentage. Block the flooding of storm
packets when the value specified for level is reached. (Range 1-100)
•
kbps
kbps
—Maximum of kilobits per second of Broadcast traffic on a port.
(Range 1 –10000000)
•
trap—(Optional)
Sends a trap
when a storm occurs on a port. If the keyword
is not specified the trap is not sent.
•
shutdown—(Optional) Shut down a port when a storm occurs on the port. If
the keyword is not specified extra traffic is discarded.
Default Configuration
Storm control is disabled.