5-9
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-07
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
Step 1
Type the time zone abbreviation and press
Enter
.
Enter time zone name [UTC]:
CET
Step 2
Type the minutes offset from UTC and press
Enter
.
Enter time zone minutes offset from UTC:
60
The local time and date are displayed, and you are asked whether you want to change them.
The local time and date is 15:00:01 CET FRI 01 July 2002
Would you like to set a new time and date? [no]:
Step 3
If the time and date are correct, go to .
If the time and date are not correct, answer yes to the above question, and press
Enter
.
Would you like to set a new time and date? [no]:
y Confirm
your response and type the new
time and date.
This change will take effect immediately both on the system clock and calendar;
it will also set the time zone you entered. Are you sure? [yes/no]:
y Enter
new local time
and date:
14:00:01 1 July 2002
Time zone was successfully set.
The system clock and the calendar were successfully set.
Step 4
You are asked whether you wish to enter the SNTP configuration menu.
If you do not wish to configure the SNTP, skip the rest of this section and go to .
To enter the SNTP configuration dialog, type
y
, and press
Enter
Would you like to enter the SNTP configuration menu? [no]:
y
Step 5
Configure the SNTP broadcast client. By default the SNTP broadcast client is not enabled.
•
To disable the SNTP broadcast client, press Enter.
•
To enable the SNTP broadcast client, type
y and
press
Enter
.
Enable SNTP broadcast client? [no]:
Step 6
Define the time interval between unicast updates.
•
To accept the displayed default value, press
Enter
.
•
To change the value, type the desired number of seconds (64 through 1024) and press
Enter
.
Enter time interval in seconds between unicast updates [1024]:
Step 7
You may enter an IP address for the SNTP unicast server. Type in the hostname or the IP address in the
form x.x.x.x, and press
Enter
.
Would you like to configure SNTP unicast servers? [no]:
y
Enter IP address or hostname of SNTP unicast server:
10.1.1.1
