8-3
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-07
Chapter 8 Troubleshooting
Troubleshooting Overview
CLI Commands for Troubleshooting
Use the following commands to provide information to help you troubleshoot installation of your SCE
2000 platform. Refer to the
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
or the
SCE 2000 and SCE 1000 CLI Command Reference
for more information.
Note
Remember that if the management interface is not operational, you should connect the SCE 2000
platform to a local console so that you can enter CLI commands for troubleshooting.
•
Troubleshooting firmware package installation:
–
boot system <filename>
— Specifies and verifies the package file to be installed. Error
messages or other output identify problems with the package file.
Following is a sample output from the
boot system
command.
SCE 2000(config)#
boot system ftp://user1:[email protected]/downloads/SENum.pkg.pkg
Verifying package file SENum.pkg.pkg…
Package file verified OK.
•
Troubleshooting the management subsystem:
–
show interface Mng
— Displays IP address and auto-negotiation information for the
management interfaces.
Following is a sample output from the
show interface Mng command
.
ip address: 10.1.6.145
subnet mask: 255.255.0.0
Configured speed: auto, configured duplex: auto
AutoNegotiation is On, link is Up, actual speed: 100, actual duplex: half
–
show ip default-gateway
— Displays the IP address of the configured default gateway.
Following is a sample output from the show ip default-gateway command.
Default gateway: 10.1.1.1
–
show ip route
— Displays the entire routing table and the destination of last resort
(default-gateway).
Following is a sample output from the show ip route command.
gateway of last resort is 10.1.1.1
–
show access-lists
— Shows all access-lists or a specific access list.
Following is a sample output from the show access-lists command.
Standard IP access list 1
Permit 10.1.1.0, wildcard bits 0.0.0.255
deny any
–
show telnet
— Displays the status of the telnet server daemon (
status
) or any active Telnet
sessions (
sessions
).
