Cisco RFGW-10, Руководство по установке оборудования

Страница: 132 / 182

5-26
Cisco RF Gateway 10 Hardware Installation Guide
OL-16264-04
Chapter 5 Installing and Removing FRUs
Installation and Removal of the Line Cards
Figure 5-15 RF Line Card Faceplate to Chassis Alignment Features
Step 10
Use a screwdriver to tighten the captive installation screws on each end of the DS-48 line card faceplate.
Note
Tighten the captive screws to 6-8 in-lbs.
Verifying the Status of the DS-48 Line Card
To check the status of the module, do the following:
Step 1
Ensure that the STATUS LED illuminates green (module operational).
Step 2
When the DS-48 is online, use the show module command to verify that the system acknowledges the
new module and that the module's status is good.
Step 3
If the module is not operational, re-seat it. If the module is still not operational, contact your customer
service representative.
Removing the DS-48 Line Card
Caution
When no fiber cable is connected, the aperture of the port may be emitting invisible radiation. Avoid
exposure to the radiation and do not stare into the apertures.
Caution
During this procedure, wear grounding wrist-straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool. This could result in an electric shock.
273861