Basic Administration of the SPA9000
Configuring Basic Settings
SPA9000 Voice System Administration Guide
33
2
SPA9000 Ethernet Port
The SPA9000 Ethernet port is used to connect an administrative computer.
Typically, this port is used only during initial installation and configuration. With
WAN access enabled by default, you can manage your SPA9000 from any
computer that is connected to the same subnetwork as the SPA9000. The default
IP address for this port is 192.168.0.1.
LAN and Application Guidelines
Although the SPA9000 can provide router and application services, it does not
have sufficient power to provide both phone and routing/application services in a
highly utilized environment. For this reason, Linksys recommends that the
SPA9000 not be used as a router at any time. Instead, use the SPA9000 as an
appliance by connecting its INTERNET port to a network switch and leaving the
ETHERNET port disconnected.
It is recommended that you leave the LAN and Application settings at the default
values.
Configuring Multicast Addressing and Group Paging
For initialization and system updates, the SPA9000 communicates with all the
client stations at once by using IP multicast. This method also is used in the group
paging application. For this reason, the SPA9000 and the SPA9xx IP phones must
reside on a network where multicasting is allowed. Default addresses are
provided, but you can change these addresses as needed.
NOTE
Make sure that the SPA9000 and the SPA900 Series phones use the same
multicast address and port number. Also make sure that you enable spanning tree
and port fast on your LAN switch, as described in the
SPA9000 Voice System
Installation and Configuration Guide
.
Downloaded from
www.Manualslib.com
manuals search engine