26
Chapter 6: Manual Installation and Setup
Windows NT
EtherFast 10/100 LAN Card
Windows NT
The following instructions will set up the EtherFast® 10/100 LAN Card in a computer running NT 4.0 Server/
Workstation. You should have your original Windows NT CD-ROM available during the installation, because you
might be asked to supply it. Always consult your NT documentation if you have questions.
To install the network driver for an NT 4.0 Server or Workstation
1. Log into Windows NT as an administrator.
2. Click on
Start
,
Settings
,
Control Panel
, and then double-click on the
Network
icon.
3. If you have not previously installed Windows NT networking on your computer, the screen shown in Figure
6-30 will appear:
• If you see this message, click the
Yes
button to install NT networking along with the EtherFast® 10/100 LAN
Card's network driver, and continue with step one on the following page.
• If you don't see this message, NT networking is already installed. Skip to the Installing the EtherFast® 10/100
LAN Card Network Driver if Networking is Already Installed section.
1. After clicking on the
Yes
button, the Network Setup Wizard window will appear.
2. When the screen shown in Figure 6-31 appears, put a checkmark next to
Wired to the network
and then
click the
Next
button.
3. Click the
Select from list...
button, shown on the screen in Figure 6-32, to select the network adapter. Or,
click the
Start Search
button to search for the adapter.
Figure 6-30: Install it Now
Figure 6-31: Wired to the Network
Figure 6-32: Search for Network Adapter