Cisco IE 3000, Руководство по настройке программного обеспечения

Страница: 222 / 874

11-36
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
Chapter 11 Configuring Switch-Based Authentication
Configuring the Switch for Secure Shell
Configuring the SSH Server
Beginning in privileged EXEC mode, follow these steps to configure the SSH server:
To return to the default SSH control parameters, use the no ip ssh { timeout | authentication-retries }
global configuration command.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2
ip ssh version [ 1 | 2 ] (Optional) Configure the switch to run SSH Version 1 or SSH Version 2.
•
1 —Configure the switch to run SSH Version 1.
• 2 —Configure the switch to run SSH Version 2.
If you do not enter this command or do not specify a keyword, the SSH
server selects the latest SSH version supported by the SSH client. For
example, if the SSH client supports SSHv1 and SSHv2, the SSH server
selects SSHv2.
Step 3 ip ssh { timeout seconds |
authentication-retries number }
Configure the SSH control parameters:
• Specify the time-out value in seconds; the default is 120 seconds. The
range is 0 to 120 seconds. This parameter applies to the SSH
negotiation phase. After the connection is established, the switch uses
the default time-out values of the CLI-based sessions.
By default, up to five simultaneous, encrypted SSH connections for
multiple CLI-based sessions over the network are available (session
0 to session 4). After the execution shell starts, the CLI-based session
time-out value returns to the default of 10 minutes.
• Specify the number of times that a client can re-authenticate to the
server. The default is 3; the range is 0 to 5.
Repeat this step when configuring both parameters.
Step 4 line vty line_number
[ ending_line_number ]
transport input ssh
(Optional) Configure the virtual terminal line settings.
•
Enter line configuration mode to configure the virtual terminal line
settings. For
line_number and ending_line_number , specify a pair of
lines. The range is 0 to 15.
•
Specify that the switch prevent non-SSH Telnet connections. This
limits the router to only SSH connections.
Step 5
end Return to privileged EXEC mode.
Step 6 show ip ssh
or
show ssh
Show the version and configuration information for your SSH server.
Show the status of the SSH server connections on the switch.
Step 7 copy running-config startup-config (Optional) Save your entries in the configuration file.