Cisco IE 3000, Руководство по настройке программного обеспечения

Страница: 119 / 874

5-19
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
Chapter 5 Configuring Cisco EnergyWise
Additional Information
Figure 5-5 EnergyWise with IP Routing
On Switch 1, to prevent a disjointed domain, manually assign Switch 2 as a static neighbor or the reverse.
Switch(config)# energywise neighbor 192.168.2.2 43440
Switch 1 discovers Switch 3 as a neighbor because they are in the same LAN.
On Switch 1, verify neighbor discovery.
Switch# show energywise neighbors
Capability Codes: R-Router, T-Trans Bridge, B-Source Route Bridge
S-Switch, H-Host, I-IGMP, r-Repeater, P-Phone
Id Neighbor Name Ip:Port Prot Capability
-- ------------- ------- ---- ----------
6 Switch-2 192.168.2.2:43440 static S I
9 Switch-3 192.168.1.3:43440 cdp S I
Switch 1 uses both static and dynamic protocols to detect neighbors.
Verify that switches are in the same domain:
Switch# energywise query name * collect usage
EnergyWise query, timeout is 3 seconds:
Host Name Usage
---- ---- -----
192.168.1.2 Switch-1 96.0 (W)
192.168.40.2 shipping.1 6.3 (W)
192.168.40.2 guest.1 10.3 (W)
192.168.50.2 shipping.2 8.5 (W)
192.168.50.2 lobby.1 10.3 (W)
Queried: 72 Responded: 72 Time: 0.65 second
In a routed network, a switch port assigned to a VLAN can be connected to a router interface. The IP
address of the VLAN SVI is 192.168.1.2, and the IP address of the router interface is 192.168.1.1.
Configure the domain:
Switch(config)# energywise domain cisco secret 0 cisco protocol udp port 43440 ip
192.168.1.2
Switch 1
Switch 3
192.16 8 .1.3
LAN 10
192.16 8 .1.2 Port 1
192.16 8 .1.1/24
Port 24
192.16
8 .2.1/24
Port 24
Switch 2
Port 1
192.16 8 .2.2
205695
LAN 20
Ro u ter A