Cisco GoQAM, Инструкция по установке и эксплуатации

Страница: 158 / 178

Chapter 8 Troubleshooting the GoQAM
142 4004834 Rev D
“Session xxx
program
error”
where xxx is a
number from
0 to 991
Minor Cause Code 1 - A cyclic redundancy
check (CRC) error was detected on a
program map table (PMT).
Cause Code 2 - A new PMT was detected.
Cause Code 3 - An attempt to create a
session failed.
Program Specific Information (PSI) table
data changed in the input stream with the
following cause codes:

Cause Code 4 - Program Association
Table (PAT) update

Cause Code 5 - PMT packet identifier
(PID) conflict

Cause Code 6 - Elementary PID
conflict

Cause Code 7 - Entitlement Control
Message (ECM) PID conflict

Cause Code 8 - Program number
conflict
Delete the session.
This is for information
only. No action is
required.
Teardown and rebuild the
session.

Check the upstream
MPEG input sources
connected to the
GoQAM

For Cause Code 8,
teardown and rebuild
the session with a
program number that
does not conflict with
the session

If the alarm does not
automatically clear,
contact Cisco Services
System
Hardware
Alarm
Major The GoQAM cannot communicate with
the RF network.

Check for loose
connections or
defective cables,
tighten any loose cable
connections, and
replace any defective
cables

Reset the GoQAM by
the power switch or, if
possible, by DNCS
control

Contact Cisco Services