Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 68 of 177
3. Specify the country in which the unit is installed by selecting the
correct option from the
Country
drop-down menu.
4. Specify the unit's operating frequency by clicking the correct
option in the
Frequency (MHz)
drop-down.
• You can change the frequency of each radio link in order to
minimize interference with other wireless networks
operating in the same area. The frequencies shown on the
Frequency (MHz)
selector are the carrier frequencies.
• Operation in the 4.9 GHz band must be enabled using a
Fluidmesh software plug-in. Refer to
for details. Note that the 4.9 GHz
band is not available in Brazil and Canada.
5. If
Advanced
configuration mode was selected, choose the
required channel bandwidth from the
Channel Width (MHz)
drop-down. Note that the radio units on both sides of a wireless
link must be set to the same channel width value. A channel
width mismatch will result in degraded communication between
the units.
IMPORTANT
If a shared passphrase is defined, the same
passphrase must be used for all Fluidmesh units in
the same network.
The shared passphrase can be composed of any
ASCII characters except the following:
'`"\$=
CAUTION
Make sure that the chosen country listing matches
the country in which the unit is installed before
changing the
Frequency (MHz)
value.
CAUTION
Different countries frequently have differing
telecommunications regulations. If the Country listing
is not set correctly, the unit may violate national
telecommunications legislation.
CAUTION
Before finalizing the settings on the
WIRELESS
RADIO
window, refer to
below. This section
contains important information that may influence
your choice of wireless settings.
