3-7
Cisco Content Delivery Engine Hardware Installation Guide
OL-13478-01
Chapter 3 Installing the Software and Initially Configuring a CDE
Running the BIOS Setup Utility
c.
Set the P-ATA Channel Selection option to
Both
.
Note
On the CDE-100, the Primary IDE Slave is connected to the internal CD-ROM, the Secondary
IDE Master is connected to 128 MB compact flash.
Step 12
Press
Esc
to return to the Advanced menu. Choose
Super I/O
Configuration
and press
Enter
. The
Configure Super I/O Chipset screen appears (see
Figure 3-10
Configure Super I/O Chipset Screen
Set the
Serial Port2 Address
option
to
Disabled
.
Step 13
Press
Esc
to return to the Advanced menu. Choose
Remote Access Configuration
and press
Enter
. The
Configure Remote Access Type and Parameters screen appears (see
).
Figure 3-11
Configure Remote Access Type and Parameters screen
a.
Set the
Serial port number
option to
COM 1
.
b.
Set the
Serial Port Mode
option to
9600 8, n, 1
.
c.
Set the
Redirection after BIOS POST
option to
Disabled
.
Step 14
When you are finished, navigate to the
Exit
submenu and choose
Save Changes and Exit
. Press
OK
when prompted (see
