3-3
Cisco Content Delivery Engine Hardware Installation Guide
OL-13478-01
Chapter 3 Installing the Software and Initially Configuring a CDE
Running the BIOS Setup Utility
Installation and Configuration Order
Perform the initial installation and configuration of your CDS network in the following order:
1.
Run the BIOS setup utility on each CDE in the CDS network.
2.
Install the CDS release 2.0 software on each CDE in the CDS network.
3.
Configure the CDSM.
Caution
It is very important that the onboard SCSI controller be disabled on the CDE-200. Do this by physically
opening the CDE-200 case (by removing two side screws and a back thumbscrew), and verifying that the
jumper labeled “JPA-1” (located about two inches below the center PCI-X slot—slot 3 of 5) has pins 2
and 3 connected (instead of 1 and 2). Pin 1 is closest to the rear of the case and pin 3 is closest to the front.
Running the BIOS Setup Utility
Running the BIOS setup utility is different for the CDE-100 and the CDE-200; therefore, this section
provides a separate BIOS setup procedure for each CDE.
Running the BIOS Setup Utility for the CDE-100
Perform the following steps to run the BIOS setup utility for the CDE-100:
Step 1
Power on the CDE-100.
Step 2
Insert the CD with the CDS image into the internal CD-ROM drive (see
).
Figure 3-2
CDE-100 Front View
Step 3
Reboot the CDE-100 and wait for the initial BIOS screen to appear.
Note
through
are required only for the initial installation. The BIOS setup does not need to be
changed for the second and subsequent installations or recovery.
Step 4
To enter the BIOS Setup menu, press
Delete
as instructed at the bottom of the BIOS screen. The Main
menu appears (see
211764
