Cisco C880 M4, Руководство по настройке

Страница: 14 / 146

© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 14 of 146
Table 1. Cisco IMC Connection Settings
Item Value
Baud rate 19200
Data bit 8
Parity bit None
Stop bit 1
Flow control None
Emulation VT100
Note:
The MMB initialization process takes about 6 minutes to complete.
After the serial connection is opened, you will see an initial message and login prompt on the terminal software
screen. Enter the login name as Administrator . This is the preset default administrator user account name. After
entering this user name, you are asked to change your password immediately.
3. Enter a new password. Then reenter the same password.
Cisco-1541432026 login: Administrator
You are required to change the password immediately (root enforced)
New password:
Retype New password:
Administrator >
Note:
To see more commands and command syntax, enter the help command.
Set the Integrated Management Controller IP Address
Now set the IMC IP address.
1. Verify that the IMC ports are connected to the management network as shown in Figure 7.
2. After resetting the password as in the previous section, enter the commands shown here to set the IMC IP
address and enable HTTP and Telnet access to it.
Administrator> set ip <ip address> <netmask>
Administrator> set gateway <ip address>
Administrator> set http enable
Administrator> set telnet enable
3. The default HTTP port is 8081. You can change this port if required by entering the following command:
Administrator> set http_port 80