Cisco C880 M4, Руководство по настройке

Страница: 96 / 146

© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 96 of 146
15.
For a multipath configuration, configure the settings described in the sections from “Start the HBA Setup
Utility and Select the HBA” to “Set Link Speed and Topology” for all the HBAs connected to the SAN
storage unit LUN from which the system is started. Also, after installing the OS and multipath driver,
perform the operation described in “Set Boot Device for All the HBAs Used to Start the System.”
16. After configuring all the settings, select Exit Emulex HBA Configuration Utility and then press the Enter
key to return to the Device Manager menu.
Note:
If following message appears after you complete the operations, press the N key or the Esc key:
You need not perform another operation here because the Commit Changes or Discard Changes operation from
the menu completes the task of changing or discarding settings.
Select the relevant item from the Delete Boot Device or Change Boot Device Order menu. Then select Commit
Changes or Discard Changes. Then return to the Delete Boot Device or Change Boot Device Order menu.
Apply the Settings
Restart the system to apply the changes in the settings. To restart the system, use the following procedure or
select Reset from the Power Control window of the MMB web user interface.
1. Press the Esc key to go to the Boot Manager main page (Figure 108).
Figure 108. Restarting the System (1)