Cisco C880 M4, Руководство по настройке

Страница: 72 / 146

© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 72 of 146
16-Gbps Fibre Channel Card Settings: UEFI Driver Version 6.11a5 or Later
This section describes the settings on the 16-Gbps Fibre Channel card in the Cisco C880 M4 Server. With these
settings, the system starts from a LUN of the SAN storage unit in the Fibre Channel SAN boot environment.
Set UEFI Driver Version 6.11a5 or Later on the 16-Gbps Fibre Channel Card
This section describes the procedure for setting UEFI Driver Version 6.11a5 or later.
To start the system from a LUN of the SAN storage unit in the SAN boot environment, the process described here
is required for all HBAs to be used to start the system. Running this process registers in the HBA the SAN storage
unit LUN from which the system is to be started.
The figures in this section use UEFI Driver Version 6.11a5. All screenshots in the figures are examples only, and
contents may vary depending on the system configuration, etc.
Note the following:
● To add sadump as the dump device for the SAN, you must set the LUN by selecting Add Boot Device in the
UEFI driver utility.
●
You must set the Fibre Channel card on each port.
When a setting is added or changed, the partition must be rebooted. Perform the operations here after rebooting
the relevant partition.
1. Reboot the system.
2. When the Cisco logo appears, press any key except the Enter key (Figure 75).