Cisco Aironet 1570 Series, Руководство по установке

Страница: 73 / 168

3-29
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
OL-32138-01
Chapter 3 Mounting the Access Point
Pole Mount Kit 2
Pole Mounting Using PMK2
You can use PMK2 for vertically mounting the AP on vertical poles, horizontal poles, and off-angle poles
of diameter ranging from 2 to 16 inches. For more information, see
Pole Mount Kit 2, page 3-23 .
Table 3-5 Materials Needed to Mount the AP using PMK2
Tip
If you need to vertically mount the AP on vertical poles of diameter ranging from 5 to 8 inches
(127 to 203 mm), you can use PMK2 without the pivot bracket. See
Vertically Mounting Without Pivot
Bracket For 4 to 8 inches Vertical Pole
To mount the AP using PMK2, follow these steps.
Step 1
Position the strap brackets on the pivot bracket according to the diameter of the pole. Secure each strap
bracket with two M8 x16 bolts (with lock washers) and M8 nuts (
Figure 3-21 ). Tighten the bolts to
13 to 15 lb.ft (17.6 to 20.3 Nm).
Step 2 Select a mounting location on the pole to mount the access point.
–
For vertical poles, position the strap and pivot brackets assembly as shown in Figure 3-24 . The
pivot bracket is oriented vertically.
– For horizontal poles, position the strap and pivot brackets assembly as shown in Figure 3-25 .
The pivot bracket is oriented horizontally.
Note If you will be using a streetlight power tap adapter, position the access point within 3 ft (1 m) of the
outdoor light control
Step 3
Mount the strap and pivot brackets assembly at the mounting location on the pole, using the two band
straps (refer
Figure 3-23 ), as follows:
–
For pole diameters more than 3.5 inch (89 mm), loop each metal band strap twice through the
slots on the strap brackets (see
Figure 3-22 ). Follow the instructions provided with the band
strap tool (BAND IT) (AIR-BAND-INST-TL=).
– For pole diameters equal to or less than 3.5 inch (89 mm), loop each metal band strap twice
through the slots on the strap brackets and also through the narrow space between the pole
clamp bracket and the strap brackets (see
Figure 3-22 ). This ensures maximum holding
strength, especially for extreme environments. Following the instructions provided with the
band strap tool (BAND IT) (AIR-BAND-INST-TL=).
Material Needed In Kit?
One PMK2 wall mount bracket Yes
Two PMK2 strap brackets Yes
One PMK2 pivot bracket Yes
Four M8 x12mm hex head bolts Yes
Eight M8 x16mm bolts (with lock washers) Yes
13 mm box-end wrench and/or socket No
Steel Band Strap banding tool (AIR-BAND-INST-TL=) No