Cisco Aironet 1570 Series, Руководство по установке

Страница: 94 / 168

3-50
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
OL-32138-01
Chapter 3 Mounting the Access Point
Pole Mount Kit 3
Wall Mounting Using PMK3
To horizontally mount the AP on a wall, you can use PMK3 without the pivot bracket and the strap
brackets. Using only the PMK3 wall mount bracket, you can horizontally mount the AP on a wall. For
more information about PMK3, see
Pole Mount Kit 3, page 3-41 .
Table 3-8
Materials Needed to Mount the AP on a Wall using PMK2
Caution
The mounting surface, attaching screws, and optional wall anchors must be able to support a 50-lb
(22.7 kg) static weight, and should conform to all local codes and regulations.
To mount the access point on a vertical wall, follow these instructions:
Step 1
Use the wall mount bracket as a template to mark four screw hole locations on your mounting surface.
The recommended screw hole locations are shown in
Figure 3-30 .
The dimensions of the PMK3 wall mount bracket is shown in Figure 3-29 .
Step 2 Using four screws and optional screw anchors, attach the wall mount bracket to the wall. Ensure that the
four screws are fully tightened.
Note
If necessary, use suitable screw anchors and an exterior-grade plywood backboard to mount the
access point to stucco, cement, or drywall.
Step 3 Screw M8 bolts into three of the four bolt holes on the back side of the access point (Screw holes 1, 4,
and 5 in
Figure 3-31 ).
Do not screw in the bolts all the way. Leave a gap of about 0.13 inch (3.3 mm).
Step 4
Position the three bolts on the access point into the wall mount bracket’s keyhole slots. Check to ensure
that the access point is properly seated in the slots. (see
Figure 3-34 )
Step 5 Screw in the fourth M8 x 12mm hex head bolt into the non-keyhole type screw hole (Screw hole 6 in
Figure 3-31 ).
Using a 13 mm open-end or socket wrench, tighten all four M8 x 12mm hex head bolts to a torque of
13 to 15 lb.ft (17.6 to 20.3 Nm).
Material Needed In Kit?
One PMK2 wall mount bracket Yes
Four M8 x12mm hex head bolts Yes
Four M8 x1.25x16 bolts (with lock washers) Yes
10 mm box-end wrench No
The mounting hardware and tools required to secure the
PMK3 Wall Mount Bracket, to wall or vertical surface,
depends on the material of the wall or vertical surface. The
mounting surface, attaching screws, and optional wall
anchors you may use, must be able to support a 50-lb (22.7
kg) static weight. No