Cisco Aironet 1570 Series, Руководство по установке

Страница: 81 / 168

3-37
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
OL-32138-01
Chapter 3 Mounting the Access Point
Pole Mount Kit 2
Vertically Mounting Without Pivot Bracket For 4 to 8 inches Vertical Pole
If you need to vertically mount the AP on vertical poles of diameter ranging from
4 to 8 inches (102 to 203 mm), you can use PMK2 without the pivot bracket. In this case, you fix the
PMK2 strap brackets directly to the PMK2 wall mount bracket.
Step 1 Position the strap brackets on the wall mount bracket as shown in Figure 3-27 .
Step 2
Secure each strap bracket with two M8 x16 bolts (with lock washers). Tighten the bolts to 13 to 15 lb.ft
(17.6 to 20.3 Nm).
Step 3 Select a mounting location on the pole to mount the access point.
Step 4
Mount the strap and wall-mount brackets assembly to the pole using the two metal band straps (refer
Figure 3-28 ). Ensure such that the AP will be oriented vertically and that the LEDs on the base of the
AP will be visible from the ground.
Loop each band strap twice through the slots on the strap bracket, and then tighten the band straps using
the band strap tool (BAND IT) (AIR-BAND-INST-TL=). Follow the operating instructions provided by
tool’s manufacturer to tighten the metal bands to full tension.
Note Installing and final tightening of the band straps are done together. After the metal bands are tightened
to full tension, the position of the AP on the pole cannot be adjusted unless the metal bands are cut or
disassembled.
Step 5 Screw an M8 x 12 mm bolt into each of the four bolt holes on the back side of the access point. Do not
screw the bolt in all the way. Leave a gap of about 0.13 inch (3.3 mm).
Step 6
Position the four bolts on the access point into the bracket’s keyhole slots. Check to ensure that the
access point is properly seated in the slots. (refer
Figure 3-28 )
Step 7 Using a 13mm wrench, tighten the four bolts that connect the access point to the bracket to a torque of
13 to 15 lb.ft (17.6 to 20.3 Nm).
Step 8
Continue with installing antennas, connecting the data cables, grounding the access point, and powering
the access point. For information on these, see
Chapter 4, “Installing Other Components.”