Cisco Aironet 1570 Series, Руководство по установке

Страница: 116 / 168

4-20
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
OL-32138-01
Chapter 4 Installing Other Components
Powering the Access Point
Note The installer is responsible for ensuring that powering the access point from this type of power
injector is allowed by local and/or national safety and telecommunications equipment standards.
Tip
To forward bridge traffic, add a switch between the power injector and controller. Refer to the
Cisco Wireless Mesh Access Points, Design and Deployment Guide, Release 7.0 for more
information.
Step 4 Ensure that the antennas are connected and that a ground is attached to the access point before you apply
power to the access point.
Step 5
Connect a shielded outdoor-rated Ethernet (CAT5e or better) cable between the power injector and the
PoE-in connector of the access point.
Step 6
Connect the Ethernet cable to the access point PoE-In port (see “Connecting an Ethernet Cable to the
Access Point” section on page 4-20 ).
Connecting an Ethernet Cable to the Access Point
You need to supply these tools and materials:
•
Shielded outdoor-rated Ethernet (CAT5e or better) cable with 0.2 to 0.35 in. (0.51 to 0.89 cm)
diameter
•
RJ-45 connector and installation tool
• Adjustable Wrench or 0.875 inch open-end wrench
•
0.5 inch or 13 mm wrench
To connect the shielded Ethernet cable to the access point, follow these steps:
Step 1 Disconnect power to the power injector, and ensure all power sources to the access point are turned off.
Warning This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit.
Statement 1028
Step 2
Ensure that access point is properly grounded as described in “Grounding the Access Point” section on
page 4-12 .
Step 3
Use a 0.5 inch or 13 mm wrench to remove the Ethernet connector cover plug which covers the Ethernet
port labeled ‘3’ on the base of the access point. See
Base of the AP, page 1-10 for more information on
where the port is located.
Do not discard the plug and rubber seal unless you are certain that the port will not have to be re-plugged.
Step 4
Loosen the sealing nut of the cable gland, which is at its round end (see Figure 4-12 ), by turning it
counter clockwise, but do not remove it.
Note
Verify that the cable gland has a rubber gasket and ensure that it is not damaged.