Cisco Aironet 1570 Series, Руководство по установке

Страница: 51 / 168

3-7
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
OL-32138-01
Chapter 3 Mounting the Access Point
Strand Mount Kit 1
Strand Mount Kit 1
The Strand Mount Kit 1 (abbreviated as SMK1) is for mounting the AP directly to a cable strand, when
there is no cable bundle. SMK1 consists of two single-piece clamps, which clamp the cable strand across
the back of the access point. As the cable strand runs directly across the back surface of the AP, there is
no space left between the back surface of the AP and the cable strand.
For instructions on mounting an AP using SMK1, see Strand Mounting Using SMK1, page 3-7 .
Strand Mounting Using SMK1
When mounting the access point on a cable strand where you don’t have to accommodate a cable bundle,
you can use the SMK1 strand mount kit.
Note
The access point must be installed on a cable strand by a professional cable installer.
Table 3-1 lists the materials you need to strand mount the AP using SMK1.
Table 3-1
Materials Needed to Mount the AP using SMK1
To mount the access point, follow these steps:
Step 1
Hold the AP’s back surface up against the support cable, and ensure that the cable runs through one of
the three sets of cable grooves.
When installing external antennas, which are mounted on the AP using an additional antenna bracket,
the AP may tilt to one side due to the uneven weight distribution. To counteract this tilt, three sets of
cable grooves are provided on the back surface of the AP. This allows you to run the cable through
different sets of the grooves so as to adjust the cable’s position against the AP’s back surface, and thereby
counter the tilt.
Material Needed In Kit?
SMK1 strand mount kit Yes
Four M8 x16mm button-head bolts, and its washers Yes
5 mm hex wrench No