10-14
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
OL-18504-01
Chapter 10 Initializing the Sensor
Advanced Setup
[2] Save this configuration and exit setup.
Enter your selection[2]:
If you receive the warning that Analysis Engine is initializing, enter
2
to save your configuration thus
far and exit setup. You can then reenter setup and press
Enter
until you are back to the interface and
virtual sensor menu.
Step 7
Enter
2
to modify the virtual sensor configuration.
Modify interface/virtual sensor configuration?[no]:
yes
Current interface configuration
Command control: Management0/0
Unassigned:
Monitored:
GigabitEthernet0/1
Virtual Sensor: vs0
Anomaly Detection: ad0
Event Action Rules: rules0
Signature Definitions: sig0
[1] Edit Interface Configuration
[2] Edit Virtual Sensor Configuration
[3] Display configuration
Option:
Step 8
Enter
2
to edit the virtual sensor vs0 configuration.
Virtual Sensor: vs0
Anomaly Detection: ad0
Event Action Rules: rules0
Signature Definitions: sig0
No Interfaces to remove.
Unassigned:
Monitored:
[1] GigabitEthernet0/1
Add Interface:
Step 9
Enter
1
to add GigabitEthernet0/1 to virtual sensor vs0.
Add Interface:
1
Virtual Sensor: vs0
Anomaly Detection: ad0
Event Action Rules: rules0
Signature Definitions: sig0
Monitored:
GigabitEthernet0/1
[1] Edit Interface Configuration
[2] Edit Virtual Sensor Configuration
[3] Display configuration
Option:
Step 10
Press
Enter
to exit the interface and virtual sensor configuration menu.
Modify default threat prevention settings?[no]:
Step 11
Enter
yes
if you want to modify the default threat prevention settings.
